B2B Catalog Collection

Gas Line Hose and Regulator for Gas 16"x34" Finisher.

15" Filter press papers for a D&G or Leader 15" filter press. There are 250 papers in a case.

This is a 2" tri-clamp fitting that will get you to 1.5" female pipe threads. Clamp and gasket sold seperate.

H2O TS-Pro Modulating Auto-Draw w/ 1" Threaded Valve. Runs on 110v. 

7" Filter Press Stop Plate for blocking off part of a filter press. 

O Ring Kit for BHR Hobby Vertical Double Releaser. Includes 12 total o-rings. 

Clip for Lapierre Super Saddle

D&G Can Sealer Kit (includes a case of 200 cans, sealer, & 25 shippers)

Lapierre Additional Valve Only for Autoflo. This would be if you wanted a second (or more) valve for your main Lapierre Autoflo as it plugs into th...

Slide Gate for Syrup Pan. Designed to hang over a partition in a pan, and block off a channel.  Not sure what pan it was designed for, or would wor...

Gasket for 2" Bulkhead Fitting

SKF Spider for Lovejoy Coupling

1" Feed Pipe Elbow for Cold Sap Inlet

Right Fire Door for Leader 2' Arch (with 2 doors). Sold as Is

Orange Metal Backer for State Signs. This backer, really makes the maple leaf pop. 

Male Garden Hose x 1/2" Male Pipe Thread.

1/8" Plastic Compression Fitting. The end with threads and the nut is 1/4" threads. 

White Metal Backer for Home Sweet Home Sign

White Metal Cover for 1 LB Printed Cream Jars.  These covers do not fit the plain glass cream jars, only the printed ones. 

Drip Tray for a Wes Fab Short Stack 7" Filter Press. A stainless pan that measures 12"x10"x2 1/2".

Hand Filter Press Pin Set

Belt for Full Size Wes Fab Filter Press.

Gas Line Hose for Gas Finisher.

Tanaka Pump Hose Coupling

Pump Priming Plug for a Tanaka Pump

Black Gas Cap for Newer Tanaka Tapper. 

1 1/2" - 2" Y Strainer Screen for a plastic inlet filter.

Sap Level Gauge Bracket - While Supply Lasts. Used to hold the top of a sight gauge on a Leader drop flue pan. 

30" Arch Pan Gasket Holder. Designed to go into the insulation that goes between the front and the back pan to make it a little more rigid so it is...

A small SS Pot with a cover that has a 1/2" female threaded fitting on the bottom. Designed to mix filter aid into a little syrup to charge a filte...

2"x1/2" Stainless Threaded Reducing Bushing

Oil Seal for 8CFM Airablo Pump Sold individually, but each pump takes 2 to rebuild. 

Bearings for 8cfm Pump head. Sold individually, but it takes 3 to rebuild a pump. 

8"x40" Membrane Storage Cannister.

3/8" Brass Threaded Plug

1 1/2" x 1/2" Stainless Thread Reducing Bushing.