Evaporators & Accessories

A piece of insulating blanket for use between the pans on 4' wide and larger archs. This blanket will come 6"x72" and is 1" thick. it can be cut wi...

Stainless Steel Pins for Insulating Arch.

Stainless Insulation Clip

Baume & Brix scale 25°-40° Baume, 45°-75° Brix. Red lines at hot and cold test. 9 3/8" long State of Vermont inspected

1" Diameter, 8" tall

2" in diameter; 8" tall

This cup is used with a short syrup hydrometer. All you need to do is fill the cup with syrup, float the hydrometer in the cup and if the dial on t...

Brix scale 50°-71°. Red lines at hot and cold test. State of Vermont inspected

12" tall; 2" diameter

45°-82° Brix

Refractometer Calibration Solution

A dry powder defoamer for your evaporator. Just sprinkle a few grains into the evaporator to keep the foam down in the pans. Works well with the de...

A small 4 ounce squeeze bottle of Atmos 300 defoamer. This defoamer works wonders at keeping the foam down while you are boiling. If you have some ...

A 8 ounce squeeze bottle of Atmos 300 defoamer. This defoamer works wonders at keeping the foam down while you are boiling. If you have some defoam...

A quart bottle of Atmos 300 defoamer. This defoamer works wonders at keeping the foam down while you are boiling. If you have some defoamer left at...

A gallon jug of Atmos 300 defoamer. This defoamer works wonders at keeping the foam down while you are boiling. If you have some defoamer left at t...

Organic Liquid Defoamer Gallon Jug.

An automatic defoamer dripper for liquid defoamer. Just fill with defoamer and mount in a hood, or over the pan and it can be adjusted to drip the ...

A small stainless cup that can be filled with defoamer and hung on the side of the pan. When the sap boils, and the foam starts rising, it will mak...

This sight gauge is for the flue pan, and comes with a 1/2" brass gate valve, 12" glass tube, and a stainless bracket to hold the top of the tube. ...

This sight gauge is for the flue pan, and comes with a 1/2" brass gate valve, 18" glass tube, and a stainless bracket to hold the top of the tube. ...

A sight tube assembly that should fit almost any place you would like to put a sight tube. It has all stainless parts no brass, and the glass tube ...

A replacement 1/2" diameter glass tube that is 12" long for a standard sight gauge.

This replacement glass tube is for Leader's Max flue pans. It has a 1/2" diameter and is 18" long.

A replacement brass valve for a sight gauge. This is just the valve that comes with the rubber gasket inside. The valve has 1/2" male threads on it...

Sap Level Gauge Gasket.

Brass Washer for Sap Level Valve.

Most producers that have tried an automatic drawoff could not imagine boiling without one again. This is a full feature Max Marcland automatic draw...

H2O 2" Modulating Automatic Draw-off with Barometric Compensation, Motorized Valve, Controller and Probe. Comes with the down spout. Has a 2" tri-c...

This is a spare/replacement temperature probe for an automatic drawoff. A spare probe can make changing drawoff sides much easier. Just change the ...

V11 - 1" Motorized Stainless Ball Valve only. This is a spare valve for use with a Marcland Max or Mini Automatic drawoff.

A rubber plunger for the inside of the Solenoid valves. This little rubber piece is what forms the seal inside the solenoid valve.

This bracket is made to hang on the side of a Leader welded flue pan and then you can mount your Marcland control box right on it. The bracket fits...

Thermometer Bracket for Welded Pan (for digital or dial therm.)

Temp. Probe Clip for Marcland Auto Drawoff temperature probe. This clip gets attached to the pan with a bolt (not included) and then the temperatur...

A digital meter that tells you the barometric pressure in inches of mercury and the boiling point of water in degrees of Fahrenheit based on the ba...